Frequently Asked Questions | Prostain

Please find below answers to our most common questions. If you need to know more, please do not hesitate to contact us.

What industries do you service?

We service all industries including commercial, industrial and domestic. Click here for our range of services.

What services do you provide?

Click here for our range of services.

Where are you located?

Our fully equipped factory is located in Melbourne's North at Factory 2, 36 Randor Street Campbellfield. Click here or call 9357 7051 to organise a tour of our establishment.

Can you provide services interstate or overseas?

Yes. We can design and build your next project in our Melbourne factory and have it shipped and installed interstate or around the world. Click here or call 9357 7051 for further information.

Can I see examples of your work?

Click here to view our Gallery showcasing some of our more recent work.

What materials do you work with?

We work with stainless steel, aluminum, copper, brass, sheetmetal, mild steel and other materials.

Can you provide a FREE no obligation quotation?

Yes. Click here or call 9357 7051 to discuss your next project with us.

Can I get stainless steel or other metals as a sample?

Prostain Fabrications can supply samples of different alloys for consideration for architectual projects.

Does stainless steel corrode?

Tea Staining occurs most commonly within about five kilometres of coastal areas or a few hundred meters from a sheltered bay, it becomes progressively worse closer to a marine source.However wind exposure, industrial pollution levels and higher temperatures can create enviroments where tea staining might occur. these same factors also increase corrosion rates of alternative metals Note: We have found a No:8 (Mirror finish) will withstand tea staining better than a No:4 (Satin finish )

Do I need to clean my job after it is installed?

Yes, stainless steel will hold its appearance & remain free of tea-staining if it is washed regularly & it is not necessary to use harsh chemicals, warm soapy water and a clean cloth is fine. Drying afterwards will avoid leaving streaky marks. With No 8 ( Mirror Finish ) surfaces if subject to excessive brushing or rubbing may lose gloss or become scratched. Bleaches are not recommended.

For more information on our servies please click here.

If you would like more information on our stainless steel fabrications, welding, design or fabrication please contact us today!